Cutting
Cut by hand circular saw or circular saw with high-speed small motor,inputted with compressed air upon cutting to blow off the aluminium powder.

Cut by Gang Saw or Shuttle Saw
Cut on the premise that panels would not be damaged,inputted with compressed air at the same time to blow off the powder.

Hole Llcked and Expanded
Drilled at high sped by an iron driller,and lubricant is strictly prohibited as it may damage the mounting surface,inputted with compressed air at the same time to blow off the powder.

Edge Planing
Filed by electric planer or metal File,and make the rough edges trimmed after cutting.Do remember to clean away the powder left on the panel surface.

Rivet Joint
Riveted by nails.

Cold Bending
Pressure shaped by special mould,no heating treatment allowed,use a protective padding to avoid damage to panel surface.

Folding
First make aluminium-plastic panel underlaid,use electric or foot shear(blade taked off)to fold.Make clear of the bottom face and rough edge upon folding.

Cold Folding
First mill a V-shaped small groove,R-2-8mm wide,and then fold.

Cold Rolling
Pressure moulded by adjustable presser and smooth round toller.Donit damage the surface while operating.

Screwed Joint
Jointed by stainless steel self-tapping screw or stainless steel wood screw.To compound large area with medium area,a washer should be used.

Glue Bonded
Bonded by metal adhesive properly,but not for the part of plastic

Welded
Use a heat sealing equipment,grooved and welded.

Clamped
Clamped by bluminium or stainless steel clip,and then jointed tightly by a nail.

Painting
Paint our the pattern as desired,maximum drying temperature not greater than 600C,or follow the technical specifications of paint factorcy.

Silk Screen Printing
Print the pattern by proper silk screen ink.